Icom IC-12GAT Instruction Manual page 23

8-3
8-4
Jump
MEMORY
TRANSFERRING
PROGRAMMED
SCAN
RELATED FUNCTIONS 8.
Copy and transfer the displayed Memory Channel
contents into the VFO mode.
Use this function to search for signals around the
Memory Channel operating frequency.
e [he Memory Channel is not erased.
1) To select the desired Memory Channel, see
Section 8 - 1, steps 1 and 2.
2) Push and hold [WR] until the speaker emits 3
beeps.
e"M' disappears from the FUNCTION DIS-
PLAY.
The Programmed Scan function scans all fre-
quencies between two frequencies. Refer to p. 27
to set the scan edges.
1) Push [V/M] until "M" or "C" disappears from
the FUNCTION DISPLAY.
2) Rotate [SOL] until the speaker is muted.
3) While pushing [FUNCTION], push [10k] up to
start an upwards scan; or push down to start a
downwards scan.
e The decimal point blinks.
e [he scan stops when a signal opens the
squelch.
e The scan waits on a signal for 15 seconds
before resuming.
e [he scan resumes 2 seconds after a signal
disappears.
4) To stop the scan, push any switch.
f C»