Golden Designs P6 Series Owner's Manual
  1. Manuals
  2. Brands
  3. Golden Designs Manuals
  4. Plumbing Product
  5. P6 Series
  6. Owner's manual

Golden Designs P6 Series Owner's Manual

1-2, 2, & 3 person saunas
Hide thumbs Also See for P6 Series:
Table of Contents

Advertisement

Quick Links

Download this manual
P6-Series
P6-H106-02 / P6-H206-02 / P6-H306-02
1-2, 2, & 3 Person Saunas
OWNER'S MANUAL
INFRARED MODEL SAUNA
FOR INDOOR USE ONLY
120V/15AMP DEDICATED CIRCUIT REQUIRED for P6-H106-02 / P6-H206-02
120V/20AMP DEDICATED CIRCUIT REQUIRED for P6-H306-02
Carefully and thoroughly read this Owner's Manual before using/operating the
sauna. We recommend keeping this Owner's Manual for regular review and future
reference. Parts and accessories may vary and are subject to change.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P6 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Golden Designs P6 Series

Summary of Contents for Golden Designs P6 Series

  • Page 1 P6-Series P6-H106-02 / P6-H206-02 / P6-H306-02 1-2, 2, & 3 Person Saunas OWNER’S MANUAL INFRARED MODEL SAUNA FOR INDOOR USE ONLY 120V/15AMP DEDICATED CIRCUIT REQUIRED for P6-H106-02 / P6-H206-02 120V/20AMP DEDICATED CIRCUIT REQUIRED for P6-H306-02 Carefully and thoroughly read this Owner’s Manual before using/operating the sauna.

  • Page 2: Table Of Contents

    TABLE OF CONTENTS Packing List Visual Assembly Diagram Schematics Schematic Layout Dimensional Diagram Screw Identification and Location Chart Highlights Assembly Instructions Operating the Sauna Tips for Using Your Sauna Safety Instructions Safeguards for Your Sauna Troubleshooting Guide Maintenance Warranty Warranty Card WARNING: Visually inspect all heaters before assembly to make sure they are not damaged.
  • Page 3 What Are Infrared Rays? Infrared is the band of light we perceive as heat. We cannot see this band of light with the naked eye, but we can feel this type of light in the form of heat. Our sun produces most of its energy output in the infrared segment of the spectrum.
  • Page 4 models range at less than 3mG (NIR heaters range at about 5mG-7mG at the same approximate 2 inches) EMF Levels from Common Homes Sources After many years and numerous studies on EMF exposure, no government body including the Occupational Safety and Health Administration (OSHA) have established permissible exposure limits (PEL).
  • Page 5 HOW IT WORKS Infrared Saunas differ from traditional saunas in that they use infrared radiant energy to directly penetrate into the body's tissue to produce perspiration. Traditional saunas use steam to heat the air inside the sauna, which then heats your body until you begin to perspire.
  • Page 6 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H106-02 – Assembly Diagram *THE ABOVE ASSEMBLY DIAGRAM IS FOR A QUICK REFERENCE VISUAL GUIDE ONLY. ALL SAUNA MODELS MAY NOT BE SHOWN. PARTS AND ACCESSORIES DO VARY AND ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 7 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H206-02 – Assembly Diagram *THE ABOVE ASSEMBLY DIAGRAM IS FOR A QUICK REFERENCE VISUAL GUIDE ONLY. ALL SAUNA MODELS MAY NOT BE SHOWN. PARTS AND ACCESSORIES DO VARY AND ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 8 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H306-02 – Assembly Diagram *THE ABOVE ASSEMBLY DIAGRAM IS FOR A QUICK REFERENCE VISUAL GUIDE ONLY. ALL SAUNA MODELS MAY NOT BE SHOWN. PARTS AND ACCESSORIES DO VARY AND ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 9 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H106-02 – Schematics *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 10 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H206-02 – Schematics *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 11 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H306-02 – Schematics *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 12 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H106-02 – Schematic Layout *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 13 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H206-02 – Schematic Layout *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 14 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H306-02 – Schematic Layout *THE PICTURES AND DIAGRAMS SHOWN WITHIN THIS OWNER’S MANUAL ARE REPRESENTATIONS OF THIS MODEL. ACTUAL MODEL MAY VARY. DESIGN AND CONSTRUCTION ARE SUBJECT TO CHANGE. BACKRESTS NOT INCLUDED.
  • Page 15 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H106-02 – DIMENSIONAL DIAGRAM...
  • Page 16 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H206-02 – DIMENSIONAL DIAGRAM...
  • Page 17 READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY P6-H306-02 – DIMENSIONAL DIAGRAM...

  • Page 18: Screw Identification And Location Chart

    SCREW IDENTIFICATION AND LOCATION CHART...

  • Page 19: Highlights

    Highlights A. High quality craftsmanship B. Temperature control C. Timer D. Infrared carbon heat emitter panels E. Control Panel: F. Power supply and sub power supply: G. MP3 Jack: H. Buckles:...
  • Page 20 Panel Descriptions For easier assembly, please understand and distinguish the differences between each panel. FLOOR PANEL When you place the FLOOR PANEL at its designated location, be sure to leave enough space so that you are able to move around the FLOOR PANEL during the assembly process.
  • Page 21 Heat emitter panels are closer to the top Figure 2 Roof Panel The ROOF PANEL houses the power supply, speakers, MP3 AUX jack, and Chromotherapy Light. Once installed, all the wiring harnesses, plugs, and connections will sit on the exterior side of the roof panel.

  • Page 22: Assembly Instructions

    Assembly Instructions Please note that your sauna has been completely assembled and tested at the factory prior to packaging. Please further note that the rear wall panel is intentional warped as part of the overall design. Two adults will be needed to assemble the sauna room.
  • Page 23 Figure 3 Figure 4 D. Installing the FRONT WALL PANEL 1. Remove any protection paper/tape from the buckles. Place the FRONT WALL PANEL up and onto the FLOOR PANEL. Next, attach the FRONT WALL PANEL to the LEFT SIDE WALL PANEL and use the buckles to latch together.
  • Page 24 Also plug in the FLOOR HEAT EMITTER PANEL connector to the corresponding inlet on the RIGHT SIDE WALL PANEL. 3. Install the BENCH at an angle as also seen in Figure 7. Then slide it over the BENCH HEAT EMITTER PANEL all the way back and against the REAR WALL PANEL.
  • Page 25 Figure 8 G. Connecting the plugs on the ROOF PANEL 1. Connect the plugs according to their respective labels on the rooftop. H. Installing the TEMPERATURE SENSOR and optional accessories (varies by model) 1. Enter the sauna and remove the protective covering (masking tape) from the TEMPERATURE SENSOR.
  • Page 26 J. Installing the DOOR HANDLE 1. The inner and outer door handles need to be mounted to the FRONT GLASS DOOR. According to Figure 11, the FRONT GLASS DOOR must sit between the (2) white washers. The screws are inserted from the inside of the FRONT GLASS DOOR and screwed into the outer handle.
  • Page 27 Figure 12 Figure 13 Figure 14 ASSEMBLY COMPLETE!

  • Page 28: Operating The Sauna

    Operating the Sauna 1. Precautions A. Please make sure your wall outlet meets the specifications required. Failure to meet the requirements may cause safety risks. a. Set the temperature and time to a comfortable level. The average used temperature range is between 118ºF – 122ºF. The average sauna session is approximately 20 –...
  • Page 29 increase quickly. Decrease the temperature in the same manner by pressing button. After the sauna reaches the desired temperature, the “Heat” light will turn off. D. Press the button to turn the light ON. If you want to use the Color Light Therapy System: 1.

  • Page 30: Tips For Using Your Sauna

    reset the timer again by pressing the H. The Fahrenheit and Centigrade display can be switched by pressing and holding the temperature button at the same time and then pressing the I. The Bluetooth function is built into the Control Panel. For the Bluetooth function, you first will need to pair your device with the sauna room.

  • Page 31: Safety Instructions

    also to avoid having too much perspiration dripping onto the floor. Never place any towels over the floor heater. If your legs become cold, you can use a third towel to drape over your legs to trap the heat. 5. This is a non-commercial sauna. For every three hours ON, the sauna must be turned OFF for one hour to cool down.
  • Page 32 Setting the desired temperature to an excessively high temperature is not recommended. 7. The use of alcohol, drugs, or medications (prescribed or non-prescribed) prior to or during the sauna session may lead to unconsciousness and/or other harmful physical injuries. 8. Persons suffering from obesity or with a medical history of heart disease, low or high blood pressure, circulatory system problems, diabetes, or other medical conditions should consult with a medical physician prior to using the sauna.

  • Page 33: Safeguards For Your Sauna

    minutes or until it cools down completely if a need to touch it arises. 22. Do not pour water or any other liquids onto the infrared heat emitters. Do not bump, hit, or break the heating elements as it may cause an electrical short and pose a safety risk.
  • Page 34 The wire junction or the heater’s Check that the connections are wire is not connected sung and tight The temperature sensor is check the connection of the broken temperature sensor The circuit board or the relay is replace the circuit board not working Odor from the sauna Power supply problem...

  • Page 35: Maintenance

    Maintenance Do not use liquid cleaners or aerosol cleansers inside the sauna. Unplug the sauna from the wall outlet before cleaning. Use plain water and a soft cloth for cleaning. Do not use benzene, alcohol, or strong cleaning chemicals in or on the sauna. NOTE: Any chemical that can damage wood or be absorbed into the wood will damage the sauna.
  • Page 36 Limited Lifetime Warranty 5 Year Limited Warranty*: Golden Designs, Inc. under the Dynamic brand name warranties the wood, structure, heating elements, and electronics against defects in material and workmanship for a period of 1 to 5 years from the original date of purchase.
  • Page 37 ▪ Outdoor applications ▪ Normal wear and tear or weathering ▪ Use of product not in accordance with instructions ▪ Worn out receptacle Surface cracks are not considered defects in material or workmanship, as they are normal characteristics of all woods. This includes minor cracks due to wood expansion and contraction.
  • Page 38 PAGE INTENITIONALLY LEFT BLANK...

  • Page 39: Warranty Card

    WARRANTY CARD Congratulations on your purchase of an Infrared Sauna from Golden Designs, Inc. Please take the time to complete the following Warranty Card and mail it back to: Golden Designs, Inc. 3550 Jurupa Street, Unit B Ontario, CA 91761 Please include a copy of your sales receipt showing date of purchase as this will serve as proof of purchase.

This manual is also suitable for:

P6-h106-02P6-h206-02P6-h306-02

Table of Contents