Summary of Contents for Golden Designs GDI-7202-01
Page 1
GDI-7202-01 / GDI-7203-01 / GDI-7206-01 2, 3 and 6 Person Steam Saunas OWNER’S MANUAL FOR STEAM MODEL SAUNAS REQUIRES 240VAC /1PHASE (30/40AMP, depending on your electrical code) DEDICATED CIRCUIT FOR THE STOVE REQUIRES 120VAC 15 AMP CIRCUIT FOR THE SAUNA Please Note: The stove must be installed by a certified electrician per the manufacturer’s manual.
Page 2
Thank you for the purchase of your new Steam Sauna! FOLLOW ALL INSTRUCTIONS AND BE CAUTIOUS OF SAFETY SYMBOLS. All electrical wiring must be performed by a qualified licensed electrician. High Voltage Symbol: Be cautious as there is the presence of a high voltage current that flows through the equipment! General Caution Symbol: Be cautious as the equipment uses electrical current that...
Page 3
the unit from the power source. 9. Allow 30 seconds between turning the control system “On” and “Off”. By allowing 30 seconds between powering the control system “On” and “Off” will prolong the life of the unit. 10. Confirm that you adhere to the correct power requirements of the control system. Connecting the control system to other than the required voltage can damage the control system and possibly cause serious injury.
Page 4
CAUTION: Exit sauna immediately if you feel dizzy, sleepy, or any discomfort. READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY GDI-7202-01 *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown.
Page 5
Schematics *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown. Parts and accessories may vary.
Page 6
CAUTION: Exit sauna immediately if you feel dizzy, sleepy, or any discomfort. READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY GDI-7203-01 *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown. Parts and accessories may vary.
Page 7
Schematics *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown. Parts and accessories may vary.
Page 8
CAUTION: Exit sauna immediately if you feel dizzy, sleepy, or any discomfort. READ ALL INSTRUCTIONS THOROUGHLY BEFORE ASSEMBLY GDI-7206-01 *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown. Parts and accessories may vary.
Page 9
Schematics *The above assembly diagram i s for quick reference only. Read all instructions before assembling. All sauna models may not be shown. Parts and accessories may vary.
TABLE OF CONTENTS Product Introduction Wall Panel Descriptions Assembly Instructions Control Panel Operation Tips for Using Your Sauna Safety Instructions Safeguards for Your Sauna Warranty Warranty Card WARNING: Visually inspect all parts before assembly to make sure they are not damaged.
Page 11
Control Panel for Radio & Lights Vent Figure 1 B. The LEFT SIDE WALL PANEL will have a vent near the bottom of the wall for the stove ventilation. The RIGHT SIDE WALL PANEL will have a stationary glass panel. The FRONT WALL PANEL will have the GLASS DOOR.
Page 12
Highlights Buckles External Buckles The external buckles are used to connect the LEFT and RIGHT SIDE PANELS to the REAR PANEL. (see Figure 3) Figure 3 Guide and Guide Inserts The guide and guide inserts are used to connect the FRONT PANEL to the RIGHT SIDE PANEL and the LEFT SIDE PANEL.
Page 13
FLOOR PANEL Figure 5 Understanding the Difference Between the Top and Bottom of the Wall Panels The (4) Wall Panels will have white plastic feet on the bottom of the wall panels. (see Figure 6) Plastic Feet are on the Underside of the Wall Panels Figure 6...
Assembly Instructions A. Choose a good location to install the sauna 1. The location must be dry, leveled, and away from any source of water. 2. The stove must be installed by a certified electrician. 3. Two adults are required for installation on model GDI-7289-01 and three adults for installation on models GDI-7389-01/GDI-7689-01.
Page 15
1. First, you will need to locate the SIDE BENCH SUPPORTS. See Figure 9. The SIDE BENCH SUPPORTS will be the same for sauna models GDI-7202-01 & GDI-7203-01. The SIDE BENCH SUPPORT for sauna model GDI-7206-01 will be different. The SIDE BENCH SUPPORT will need to be screwed to the RIGHT SIDE WALL PANEL using the 1 7/8”...
Page 16
2. It is time to locate the BENCH SUPPORT PANEL. Depending on your sauna model will determine how many BENCH SUPPORT PANELS you have. For sauna models GDI-7202-01 and GDI-7203-01, you will have only one BENCH SUPPORT PANEL. For sauna model GDI-7206-01, you will have two BENCH SUPPORT PANELS.
Page 17
GDI-7202-01 & GDI-7203-01 BENCH SUPPORT PANELS GDI-7206-01 Figure 10 3. See Figure 10 and locate the BACKREST. You will need to screw the BACKREST to the wood plank on the REAR WALL PANEL. (see Figure 11) Wood Plank on REAR WALL PANEL...
Page 18
I. Installing the GLASS DOOR HANDLE and ROOF PANEL 1. Locate the GLASS DOOR HANDLE. The GLASS DOOR will need to sit between the plastic washer (on the outside) and the wood handle (on the inside). (see Figure 12) 2. Place the ROOF PANEL over the wall panels carefully. Be cautious when feeding the wires for the lights from the REAR WALL PANEL to the top of the ROOF PANEL.
Page 19
J. Installing the Stove Please Note: The stove must be installed by a certified electrician per the manufacturer’s manual. The stove must be installed per the electrical code in your area with reference to the breaker and wire sizes & wire material. Be sure to follow the manufacturer’s manual for proper and safe installation of the stove.
Page 20
2. Next, you will need to mount the wood housing to the sauna wall panel using the provided screws. You will install the wood housing around the stove as the stove does get very hot. (see Figure 15) Figure 15 ASSEMBLY COMPLETED!
Page 21
SAUNA CONTROL PANEL - GENERAL INTRODUCTION 1. Description of Functions Functions Touch Key technology √ FM Radio √ Reading Lamp √ Background Lamp and Star Lights √ Bluetooth Music Play √ 2. Control System Specifications A.) Rated Voltage: AC100V-AC240V B.) Bluetooth Approximate Effective Distance: 33 feet C.) Rated Power: 50Hz/60Hz 3.
5. Control Panel Display CONTROL PANEL OPERATION 1. “ “: Powers the unit “ON/OFF”. A.) Press the “ “ to turn the Control Panel “ON”. The LED will display “ “, which means the Control System has powered “ON”. In addition, the Reading Lamp should be “ON”...
Page 23
A.) Press the “ “ to turn on the Background Lamp and Star Lights. The LED will show “ “. Press the “ “ again to turn the Background Lamp and Star Lights “OFF” and the “ “ will disappear. 4.
Once the Bluetooth is connected to your musical device, the “ “ and “ “ will stop flashing. If the “ “ and “ “ continue to flash, then your musical device has not connected to the Bluetooth. To disconnect your device from the Bluetooth, turn off your device and press “...
10) After the sauna session is over, do not jump into the shower or bath immediately. Because your body was heated up during the sauna session, it will continue to perspire even after you exit the sauna room. Sit in the sauna with the door open slightly and let your body cool down. Once your body has cooled down and you feel comfortable, you can exit the sauna.
16) Do not touch the glass door hinges during sauna use as they become very hot to the touch. 17) Your hands must be dry and free of moisture before plugging and unplugging cords and wiring harnesses from the power supply and circuit boards. Never operate the sauna with wet hands or wet feet to avoid risk of electric shock.
Page 27
*Limited Lifetime Warranty: Golden Designs, Inc. warranties the sauna room and its attached electronics against defects in material and workmanship for the life of the product from the original date of purchase. This sauna is for indoor use or outdoor use when protected from the outdoor weather elements by a structure that includes a water-proof roof.
Page 28
Disclaimers Golden Designs, Inc. shall not be liable for loss of use of sauna or other Golden Designs, Inc. products or other secondary or incidental or consequential costs, expense or damages - which may include the removal of permanent structures or other custom fixtures or the necessity for crane removal - arising directly or indirectly out of the use or inability to use the product.
WARRANTY CARD Congratulations on your purchase of an Infrared Sauna from Golden Designs, Inc. Please take the time to complete the following Warranty Card and mail it back to: Golden Designs, Inc. 3550 Jurupa Street, Unit B Ontario, CA 91761 Please include a copy of your sales receipt showing date of purchase as this will serve as proof of purchase.
Need help?
Do you have a question about the GDI-7202-01 and is the answer not in the manual?
Questions and answers