Using The Local Terminal For Unit Setup And Management; Getting Started With The Local Terminal - Alvarion BreezeNET PRO.11 Series User Manual

3. USING THE LOCAL TERMINAL FOR UNIT
SETUP AND MANAGEMENT
BreezeNET PRO.11 series units feature plug-and-play operation; the unit starts
operating immediately following physical installation with a set of default
parameters. System-specific configuration of the unit to meet specific requirements
can be done via a local terminal (ASCII ANSI terminal or PC) connected to the
unit.
This chapter explains how to use the local terminal to configure and manage the
BreezeNET PRO.11 series units described in Chapter 1, with the exception of the
SA-PCR card. Configuration and management of the SA-PCR card is described in
Chapter 4.

3.1 Getting Started with the Local Terminal

1. Use the Monitor cable supplied with the Access Point. Connect one end of the
cable to the MON jack on the rear panel of the unit and the other end to the
COM port of the terminal.
2. Run a terminal emulation program (such as HyperTerminal).
3. Set the communication parameters to the following:
4. Click Enter. The main menu (see Figure 3-1) is displayed.
BreezeNET PRO.11 Series
Baud Rate:
Data Bits:
Stop Bits:
Parity:
Flow Control:
Connector:

Using the Local Terminal for Unit Setup and Management

9600
8
1
None
None
Connected COM port.
3-1
User's Guide