Alvarion BreezeNET PRO.11 Series User Manual page 86

SA-PCR PRO.11 PC Card Installation, Setup, and Management
If you selected the Shared Key algorithm, proceed to set the following parameters:
Default Key ID – Sets the default key for encryption in the Authentication
process. This is the encryption key that will be used for transmissions between
the station and the AP.
WEP Key – Define the encryption keys used for transmissions between the
station and the AP. Specify each key by clicking the appropriate WEP Key
row (First, Second, Third or Fourth) and entering 10 Hex digits (5 pairs of
characters) for each of the 4 keys.
To configure security parameters in ODI/DOS environment, use the brzsetup
application.
Note:
User's Guide
The default Key ID you enter for the SA-PCR must match the Key ID defined in
the AP. Section 3.4.6 describes the procedure for setting the encryption keys
for BreezeNET APs.
It is recommended to change the encryption keys periodically, to enhance
system security.
4-22
BreezeNET PRO.11 Series