Station Status Tab - Alvarion BreezeNET PRO.11 Series User Manual

SA-PCR PRO.11 PC Card Installation, Setup, and Management
In addition, the Configuration windows contain the following buttons:
OK – Implements any changes you made and closes the window.
Undo – Causes the window to display currently active values. This is useful if
you started changing values and you want to start again from the current
values.
Cancel – Closes the window without implementing any changes you made.
Apply – Implements any changes you made but leaves the window open.

4.5.1 Station Status Tab

The Station Status tab of the SA-PCR Configuration utility displays information
regarding the card and the card's status.
The Station Status tab contains the following parameters:
Network Type – In the current version, the value of this parameter should be
always set to Infrastructure.
Firmware Version – Displays the version of unit's current firmware
(internally installed software). The first two numbers of the firmware and
driver versions should be identical. The remaining numbers (if any) indicate
the minor version. The final letter indicates the hardware version.
Driver Version – Displays the version of unit's current driver.
MAC Address – Displays the unit's unique IEEE MAC address.
BSS Address – The MAC address of the AP with which the unit is currently
associated.
Station Status – Current status of the unit. There are three options:
User's Guide
Scanning – The unit is searching for an AP with which to associate.
Associated – The unit is associated with an AP and has adopted the
attached PC MAC address.
4-14
BreezeNET PRO.11 Series