Using The Rubber Feet; Stacking The Router; Wall Mounting - 3Com OfficeConnect 3CRWDR200A-75 User Manual

C 2: H
HAPTER
20
Using the Rubber
Feet

Stacking the Router

Wall Mounting

I
ARDWARE NSTALLATION
allows easy viewing of the front panel LED indicator lights, and
access to the rear panel connectors, if necessary.
When positioning your Router, ensure:
It is out of direct sunlight and away from sources of heat.
Cabling is away from power lines, fluorescent lighting fixtures, and
sources of electrical noise such as radios, transmitters and broadband
amplifiers.
Water or moisture cannot enter the case of the unit.
Air flow around the unit and through the vents in the side of the case
is not restricted. 3Com recommends you provide a minimum of 25 mm
(1 in.) clearance.
Use the four self-adhesive rubber feet to prevent your Router from
moving around on your desk or when stacking with other flat top
OfficeConnect units. Only stick the feet to the marked areas at each
corner of the underside of your Router.
If you are stacking your Router with other OfficeConnect units, install the
Router at the top of the stack. Refer to the documentation supplied with
your other OfficeConnect unit for details on using the stacking clip.
A stacking clip is not supplied with the Router. Use the stacking clip
supplied with another stackable OfficeConnect unit.
There are two slots on the underside of the Router that can be used for
wall mounting.
When wall mounting the unit, ensure that it is within reach of the power
outlet. Don't install the Router more than 200 centimeter above the
ground.