3Com OfficeConnect 3CRWDR200A-75 User Manual page 18

C 1: I
HAPTER NTRODUCING THE
16
R
OUTER
Flashing quickly - Indicates one of the following conditions:
The Router has just been started up and is running a self-test routine,
or
The administrator has invoked the Reset to Factory Defaults
command, or
The system software is in the process of being upgraded
In each of these cases, wait until the Router has completed the current
operation and the alert LED is Off.
Flashing slowly - The Router has completed the Reset to Factory
Defaults process, and is waiting for you to reset the unit. To do this,
remove power, wait 10 seconds and then re-apply power. The Router will
then enter the start-up sequence and resume normal operation.
If you have used a cable to reset the unit to Factory Defaults,
to Factory Default" on page
On for 2 seconds, and then off - The Router has detected and prevented
a hacker from attacking your network from the Internet.
Continuously on - A fault has been detected with your Router during the
start-up process. Refer to
2 Power LED
Green
Indicates that the Router is powered on.
3 Wireless LAN (WLAN) Status LED
Yellow
If the LED is on it indicates that wireless networking is enabled. If the
LED is flashing, data is being transmitted or received. If the LED is off,
the Wireless LAN has been disabled in the Router, or there is a problem.
Refer to Chapter
4 Four LAN Status LEDs
Green (100 Mbps link) / yellow (10 Mbps link)
If the LED is on, the link between the port and the next piece of network
equipment is OK. If the LED is flashing, the link is OK and data is being
72.
Chapter 6
6"Troubleshooting".
"Troubleshooting".
See "Reset