Bridging Mode
Figure 20 Bridging Mode Screen
To set up the Firewall Router for use as a bridge in which the router is
the bridge between WAN and LAN, use the following procedure:
1 Enter the name for the bridging service.
2 Enter the IP Address and Subnet Mask for the LAN. See
Settings"
Figure 21 LAN IP Address Screen
LAN Settings
This screen displays a suggested LAN IP address and subnet mask of
the Firewall Router. It also allows you to change the IP address and
subnet mask.
1 Primary IP Address: Enter the first IP Address for your LAN interface.
2 Subnet Mask: Enter the Subnet Mask for your LAN interface.
3 Enable DHCP server on the LAN: Check this box to enable the DHCP
service on the router. See
Accessing the Wizard
"DHCP"
in this section.
39
"LAN