Siting Officeconnect Remote; Siting Officeconnect Remote On A Desk; The Rubber Feet - 3Com 3C410012A - OfficeConnect Remote 531 Access Router Getting Started Manual

2-2 C 2: I
HAPTER

Siting OfficeConnect Remote

When siting OfficeConnect Remote, ensure:
It is accessible and cables can be easily connected.
It is out of direct sunlight and away from sources of heat.
Cabling is away from power lines, fluorescent lighting fixtures,
and sources of electrical noise such as radios, transmitters and
broadband amplifiers.
Water or moisture cannot enter the case of the unit.
Air flow around the unit and through the vents in the side of the
case is not restricted. We recommend that you provide a
minimum of 25mm (1 inch) clearance around the unit (or stack).
To prolong the operational life of the equipment:
Never stack OfficeConnect units more than four high, and ensure
that they are clipped securely together.
Do not place objects on top of any unit or stack.

Siting OfficeConnect Remote on a Desk

If the OfficeConnect Remote is to be sited on a desk or table, units
may be stacked on top of each other. The following equipment is
provided for this purpose:
Four stacking clips to secure the units.
Rubber feet for stability.

The Rubber Feet

The self-adhesive rubber feet prevent the unit from sliding around on
a desk. Use them on a single unit, or on the bottom unit of a stack.
Stick the feet to the marked areas at each corner of the underside of
the unit
NSTALLATION
(Figure 2-1).