3Com OfficeConnect 3CRWDR200A-75 User Manual page 78

C 5: R
HAPTER OUTER
76
C
ONFIGURATION
Figure 51 RIP screen
Setting Up RIP
Check the Enable Global RIP Mode check box check box to configure
RIP on the Router.The screen displays RIP information for the LAN
interface and WAN interface. To set up or change the information for
one or both interfaces:
1 Select one of Disable, Enable or Silent from the Operation Mode
drop-down list. If you select Enable, the Router transmits RIP update
information to other RIP enabled devices. If you select Silent, the
Router only receives RIP update messages.
2 Select either 1 (for RIPv1) or 2 (for RIPv2) from the Version drop-down
list. 3Com recommends that you use RIPv1 if there is any RIP enabled
device on your network that does not support RIPv2. In all other cases,
select RIPv2.
3 Select either Enable or Disable from the Poison Reverse drop-down
list. Poison Reverse is a feature that helps prevent data loops.