Configuring Access To The Web Interface - 3Com 4007 Implementation Manual

76 C 4: C
HAPTER ONFIGURING AND
Configuring Access to
the Web Interface
U EME O
SING PTIONS
2 Assign the terminal settings using the following command:
set terminal <port> <baud, data_bits, hangup, mode, parity,
stop_bits, terminal_type>
Set the terminal to match the remote terminal settings.
3 Enable SLIP mode using the following command:
set terminal <port> mode slip <address>
where is auxiliary or console, and
<port>
IP address.
To end the SLIP session do one of the following:
From a remote SLIP connection, send a break character to the EME
From the EME command line interface, set the SLIP port to command
mode or disable the interface.
To enable or disable access to the embedded Web management
interface, use the following commands at the prompt:
set web access disable
set web access enable
To set a time value for the Web interface session to time out, use the
following command at the prompt:
set web timeout system <time period>
The available time span is 0 - 30 minutes with 0 indicating there is no
timeout.
You can view the current settings on your system for Web Access and
Web Timeout through the following EME commands:
show web access
show web timeout
is the workstation's
<address>