Deleting Specified Files From The File System; Deleting All Files And Resetting The Management Module - 3Com 4007 Implementation Manual

102 C 4: C
HAPTER ONFIGURING AND
U EME O
SING PTIONS
82904 Jul 25 1999
82904 Jul 25 1998
Number of files:
Number of bytes in file system:
Number of bytes used:
Number of bytes available:
Number of bytes cleaned:

Deleting Specified Files From the File System

The
clear file <filename>
the files that you specify from the file system. If you enter
all files, the system prompts you to confirm that you want to delete each
file before you delete it. If you enter
the file. Example:
CB9000> clear file all
Are you sure you want to delete file EventLog?(y/n): n
Are you sure you want to delete file a.1 (y/n): y
File a.1 deleted.
Are you sure you want to delete file a.11? (y/n): y
File a.11 deleted.
The system continues to prompt you about files until all files are either
deleted or saved.

Deleting All Files and Resetting the Management Module

The
clear file_system
file system, reinitializes the file system, and resets the Management
Module. This command clears the file system even if files are currently
open or being updated.
Use this command only if the combined number of bytes that individual
files use is inconsistent with the figure in the Number of bytes used: field
in the display. The number of bytes that each file uses appears
show file
in the FileSize column of this display.
CAUTION: This command deletes all files from the file system and
reinitializes the file system storage area. Do not use this command unless
the file system has been corrupted in some way.
9:52:15 BladeConfig.06.01
9:52:19 BladeConfig.05.01
and
clear file all
(no), the system does not delete
n
command deletes all files that are stored in the
13
11945984
1157120
10788864
10788864
commands delete
to delete
all