3Com 4007 Implementation Manual page 255

4 On each Multilayer switching module with VLANs that you want to
perform routing, define a routing interface for each protocol-based or
network-based VLAN. Verify that the routing interface is defined to use
the same network or subnetwork as any other module that supports the
VLAN.
5 Use the EME to connect to the switch fabric module and configure all
VLANs that will pass traffic through the Layer 2 switch fabric module (that
is, VLANs that are associated with switching modules or the GEN
interface modules).
a For each VLAN definition that is associated with one or more
switching modules, include the switch fabric module backplane ports
that correspond to the VLAN's participating switching modules. (For
example, if the VLAN's participating modules reside in slots 3 and 5,
include switch fabric module ports 5 and 9 in the VLAN definition on
the switch fabric module.) Tag these switch fabric module ports if the
backplane ports of the corresponding switching modules are tagged.
(For each VLAN, verify that the tagging type for a switch fabric
module port matches its associated backplane switching module
port.)
b For each VLAN definition for 2-port GEN interface modules, include
the switch fabric module backplane ports that correspond to the
VLAN's GEN interface modules. (For example, if the VLAN's GEN
interface module resides in slot 6, you define switch fabric module
ports 11 and 12 to be part of the VLAN.) Tag these ports if the
front-panel ports of the GEN interface modules are connected to
IEEEE 802.1Q enabled devices, such as other Switch 4007 systems or
other 3Com switches.
Key Guidelines for Implementation 255