Key Concepts; How To Set And Modify Module Parameters; Terminology - 3Com 4007 Implementation Manual

Key Concepts

How to Set and
Modify Module
Parameters

Terminology

This section explains how to set and modify module values for applicable
parameters and defines terms that are used during each process.
The module parameter values are set at the factory or during power-on.
The basic steps for setting or modifying module parameter values are:
1 Connect to a module. The
2 Select from the
module
screen appears.
3 Select an option from the module
that option appears with information and other options, if applicable.
4 Read the screen for details explaining how to modify or quit the module
screen.
menu options
Before you use the module parameters to set or modify function values,
review the following terms:
Reset — Option in the
values to their factory defaults.
Staging — Option in the
to its default factory settings after you hot-swap it into another
Switch 4007 chassis. If enabled, the module retains its nvData settings
after you hot-swap it into another Switch 4007 chassis.
If the module being hot-swapped is the same type as the module that
was removed from a chassis, the hot-swapped module learns the
previous module's settings from the EME module that is installed in the
chassis.
screen appears.
menu options
screen. The module
menu options
menu options
menu. Use this option to reset module
nvData
menu. If disabled, the module resets
nvData
Key Concepts 135
menu options
screen. The screen for