Configuring The Master Router; Configuring Router 2 As The Backup Router - 3Com 4007 Implementation Manual

CB9000@slot3.1 [12-E/FEN-TX-L3] (): ip vrrp define
Enter virtual router's type (Primary,Backup) [Primary]: primary
Enter VLAN interface index {2|?} [2]: 2
Enter VRID (1-255) [1]: 52
Enter address mode (auto-learn,IP-address) [auto-learn]: auto
Enter primary IP Address index {1-2|?} [1]: 1
Enter the advertise interval in sec (1-255) [1]: 1
Enter Authentication Type (none,pass) [pass]: none
------------------------------------------------------------
CB9000@slot3.1 [12-E/FEN-TX-L3] (): ip vrrp mode
Enter VLAN interface index (2|?) [2]: 2
Enter virtual router ID (52|?) [52]: 52
Vrid 52 - Enter virtual router mode (enabled,disabled) [disabled]: enable
------------------------------------------------------------
CB9000@slot3.1 [12-E/FEN-TX-L3] (): ip vrrp detail all all
VLAN Index: 2 Ports: 13
VRID State Interval
52 Master 1 sec.
Address
44.4.4.1
55.5.5.1
Configuring Router 2
as the Backup Router

Configuring the Master Router

Pri Preempt
255 yes
PrimaryIpAddr
44.4.4.1
Configuring Router 2 as the Backup router, as shown in Figure 48,
involves the following tasks:
Configuring the Protocol (IP) VLAN of the Backup Router
Configuring the IP Interfaces
Configuring the Backup Router
Mode Auth Password
enable none N/A
MasterIpAddr
44.4.4.1
Configuring VRRP 417
AddrMode Error
learn none