Ans Teaming Types - StarTech.com STCST2000SPEXI Manual

Remove the ANS teams and VLANS involved in the LBFO
3.
team and recreate them. This is an optional (all bindings
are restored when the LBFO team is removed ), but strongly
recommended step
NOTE: If you add an Intel AMT enabled port to an LBFO team,
do not set the port to Standby in the LBFO team. If you set the
port to Standby you may lose AMT functionality.

ANS Teaming Types

Adapter Fault Tolerance (AFT) - provides automatic
redundancy for a server's network connection. If the primary
adapter fails, the secondary adapter takes over. During normal
operation, the backup adapters are in standby. Adapter Fault
Tolerance supports two to eight adapters per team. This
teaming type works with any hub or switch. During normal
operation, the backup adapters are in standby. All team
members must be connected to the same subnet.
Switch Fault Tolerance (SFT) - provides failover between
two adapters connected to separate switches. Switch Fault
Tolerance supports two adapters per team. Spanning Tree
Protocol (STP) must be enabled on the switch when you create
a SFT team. During normal operation, the secondary adapter is
in standby. When SFT teams are created, the Activation Delay
is automatically set to 60 seconds. This teaming type works
with any switch or hub. All team members must be connected
to the same subnet. In SFT teams, each adapter in the team can
operate at a different speed than the other.
Instruction Manual
20