Verify Anti-Tip Bracket Engagement - Cosmo COS-GRC304KB Installation Instructions Manual

VERIFY ANTI-TIP BRACKET ENGAGEMENT

Do not operate the range if its rear foot is not engaged in the slot of the floor-
mounting anti-tip bracket or its rear pin is not engaged under the arm of
wall-mounting anti-tip bracket.
IMPORTANT: If the range is pulled away from the wall for any reason, always
verify anti-tip bracket engagement again.
1. Place the outside of your foot against
the bottom of the front panel to keep
the range from moving, and then
grasp the back of the range, as shown.
2. Carefully and slowly attempt to tilt the
range forward.
•
If you encounter immediate
resistance, the rear foot or the
rear pin is engaged with the anti-
tip bracket. Go to Step 5.
•
If the rear of the range lifts more
than 1/2" (1.3 cm) off the floor
without resistance, stop tilting the
range and lower it gently back to
the floor. The rear foot or the rear
pin is not engaged with the anti-
tip bracket. Proceed to Steps 3
and 4.
IMPORTANT: If there is a snapping or popping sound when tilting the
range, the range may not be fully engaged with the anti-tip bracket.
Check to see if there are obstructions keeping the range from sliding
to the wall or keeping the rear foot or the rear pin from engaging
with the bracket. Verify that the bracket is held securely in place by
the mounting screws.
3. Slide the range forward, and verify that the anti-tip bracket is securely
attached to the floor or wall.
4. Slide range back so the rear foot or the rear pin is engaged with the anti-
tip bracket.
44