SelectBlinds LEVOLOR Installation Manual

INSTALLATION GUIDE
ROLLER SHADE
LIFT SYSTEMS: CORDLESS LIFT
The difficulty level of this installation is ranked at Level 1 - A piece of cake!
If you have questions or get stuck, call our Customer Care Team at 888-257-1840, or email customercare@selectblinds.com
CASSETTE
BRACKETS
1.
MOUNTING THE BRACKETS
NOTE: The roller shade is pre-installed in the cassette headrail, which simply snaps
onto the provided hardware. You will receive two or more cassette brackets,
depending on the width of your shade.
INSIDE MOUNT
1. At the top corners of the window, measure inward and mark with your pencil 2" - 4"
from each side. If you have additional brackets, make an additional mark for each one,
evenly spaced between the outer marks.
2" - 4"
2. Next, you'll need to measure how deep to place your brackets in
the window. Starting at one of your marks, measure back at least
13/16", and make a mark with your pencil.
If you want the front of the blinds to be flush with the wall, measure
back 3" (with exposed roll version) or 3 7/8" (with cassette version)
and make a mark.
Repeat this step until you've marked the same depth measurement
for each bracket.
3. Hold each bracket up to the ceiling or window frame so the
release lip lines up with your mark. Mark the holes in each bracket,
then use your pencil to mark where the screws will go. Repeat this
step until you've marked the screw holes for each bracket.
CORDLESS
HANDLE
INSTALLATION GUIDE
FRONT HOOK
SCREW HOLES
(INSIDE MOUNT)
2" - 4"
| ROLLER SHADES JULY 23 2024
BACK HOOK
SCREW HOLES
(OUTSIDE MOUNT)
1
UPDATED