Ground Stack Installation; Kh7P I; Needed Equipment; Ground Stack Array - K-array FIRENZE-KH7P I User Manual

Ground Stack Array

Key hardware components must be inspected
before each use.
Any rigging components found to be defective,
or even suspect might be defective should be
replaced with equivalent approved part.
Always use properly rated installation hardware.
K-array is not responsible for any installing
equipment and
manufactured by K-array.
Check building codes for weight distribution
requirements. Ensure that the total weight of the
loudspeakers and additional hardware assembly
in use is lower than the Working Load Limit (WLL).
Ground stacking the loudspeaker systems shall be
accomplished by knowledgeable and experienced
professionals.
Install the loudspeaker stack on a plain horizontal
surface.
Ensure that the location for the loudspeakers
stack and its support system provides for the
minimum clearances required for safety.
It is the user's responsibility to secure the
loudspeakers stack and its support system to
ground in order to avoid any damage or failure due
to any unintended hits, gust of wind, vibrations or
such.
accessories that are
Firenze-systems

Ground Stack Installation

KH7P I

A single unit of KH7P I can be positioned on a flat surface in a
horizontal position without any additional accessories. Ensure
that the rubber feet are facing downwards. To put a single unit
in vertical position or to ground stack a KH7P I cluster use the
KH7-BASE accessory. Up to 3x units can be stacked in horizontal
position and up to 2x units can be stacked in a vertical position.

Needed equipment

not
Name Description
Dolly for preparing
KH7-DOLLY4 4x KH7P I in V stack
up to 6x in H
Stacking hardware for
2x KH7P I vertical stack
KH7-BASE
3x KH7P I horizontal
Image
stack
User Guide
Apply to
KH7P I
17