Page 1
T330 PoC Radio Quick Guide Please read carefully the Safety Information before using the product.
Page 2
Appearance Antenna Indicator light Power/volume knob Earphone/microphone jack PTT key Up key Down key Side key 1 Menu key Side key 2 Microphone Speaker...
Page 3
Attachments Name Radio Battery Antenna Power adapter USB cable Belt clip Quick Guide Safety Information Strap Desktop charger (optional) Statement of Rights Unless with written consent by our company, it is prohibited to copy, transfer, distribute or store any content in this document in any form. Under the principle of continuous improvement, our company reserves the right to modify, improve and withdraw any information in this document without prior notification.
Page 4
Installing/Uninstalling Accessories 1. Installing the battery To install the battery, aim the battery pack at the battery slot of the radio, and then push it forward. When a "click" is heard, the battery is locked. 2. Removing the battery To remove the battery, turn off the radio, press the battery latch at the bottom of the radio, and draw out the battery backward.
Page 5
Charging the battery The battery is not charged when delivered, so it has not reached its normal capacity. Therefore, please charge the battery before starting using it. After long-term storage (more than 2 months), the battery should be charged as well before use. After charging/discharging for two or three times, the battery capacity will reach the optimal state.
Page 6
LED indicator Red light on: Transmission or charging is under progress. Green light: Signals are being received. Icons RSSI Indicate signal strength. Remaining ba- Indicate remaining battery ttery capacity capacity. Keyboard lock Indicate the keyboard is locked. Backlight on Enable always-on backlight. Enable mute mode.
Page 7
Basic Operation 4. Selecting a member Method 1: In standby state, click the 【Menu key】, select Member Selection and then Group Member, press the 【Up/Down key】 to select a member, and press the 【Menu key】. To exit, hold down the 【Menu key】. Method 2: In standby state, hold down the 【side key 2】.
Page 8
Basic Operation 8. PTT settings In standby state, click the【Menu key】, select PTT Settings. To quit, hold down the【Menu key】. ① Sound quality: Set standard or high-definition sound. ② Alert tone: Enable/disable alert tone, and set a volume level. ③ Screen on via PTT: In screen-off state, whether to turn on the screen when the PTT key is pressed.
Troubleshooting Problem Solution Reason 1: Low battery. Solution: Charge or replace the battery. Power-on failed Reason 2: SIM card failed. Solution: Check or replace SIM card. Reason 3: Battery in poor contact. Solution: Reinstall the battery or clean its contacts. Insufficient Reason: Battery performance dropped.
Page 10
FCC Statement 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 11
Use careful with the earphone maybe possible excessive sound pressure from earphones and headphones can cause hearing loss. Hereby, Kirisun Communication Co.,Ltd. declares that this product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.
Need help?
Do you have a question about the T330 and is the answer not in the manual?
Questions and answers