Clealing All The Remote Control Sett Ngs; Direct Function - Pioneer VSX-D712 Operating Instructions Manual

Controlling the rest of your system
If the correct code has been input the power
ofthecomponentbeing nput will turn on or
off.
The power of the component being input will
only turn on or off if that component is able to
be turned on d rectly by iemote control,
• You can only input a code for the compo-
nent type wr tten on each MULTI
CONTROL button (except RECEIVER and
TUNER),
• Even if you don't nput a preset code for
the TV (TV/SAT MULTI CONTROL button)
you wll be able to control youl TV using
the ded cared "IV CONTROL on the
iemote if you have ass gned it to the TV
CONT button.
• You may not be able to usea part cular
code even if it is listed on page 63.
• The remote contrd buttons will not be
able operate other equipment unless
preset with the method above.
4 Repeat steps 2 through 3 to try a
different code, or to enter a code for
another component you want to control.
5 When you're done, press RECEIVER.
Clearing all the remote
control settings
You can clear all presets and _store the
factory default settings.
• While pressing the RECEIVERbutton,
press and hold the 0 button for three
seconds.
The LED blinks three times ndicating the
settings have been restored to the factory
presets.
Direct function
• Default setting ON
You can use the direct function feature to
control ane component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the
remote control to set up and listen to a CD on
the rece vet and then use the remote control
to rewind a tape in you_ VCR while you
continue to Isten to youl CD player.
When direct functon s on, any component
you select (using the MULTI CONTROL
buttons ) will be selected by both the receiver
and the remote control. When you turn direct
funct an off, you can operate the remote
control without affecting the receiver.
1 While pressing the RECEIVER button,
press and hold the 4 button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights.
3 Use the number buttons to enter
either 1 (direct on) or 2 (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you're done, press RECEIVER.
r_Note
• You can't use dilect function for TUNER.
Er_