Related Manuals for FuzzDog Angry Chuck V3
Summary of Contents for FuzzDog Angry Chuck V3
- Page 1 Angry Chuck V3 JCM800 in-a-box Contents of this document are ©2020 Pedal Parts Ltd. No reproduction permitted without the express written permission of Pedal Parts Ltd. All rights reserved.
-
Page 2: Important Notes
Important notes If you’re using any of our footswitch daughterboards, DOWNLOAD THE DAUGHTERBOARD DOCUMENT • Download and read the appropriate build document for the daughterboard as well as this one BEFORE you start. • DO NOT solder the supplied Current Limiting Resistor (CLR) to the main circuit board even if there is a place for it. - Page 3 Schematic + BOM TL072 LM833 100p 220n D1,3 3mm red LED 100n 1N4001 100p 470R 2u2 elec 100KB 2u2 elec 100KA BASS 25KB 25KB TREB 100KB 2u2 elec 100n 100u elec 100u elec Based on the trace published at FreeStompBoxes.org...
- Page 5 The power and signal pads on the PCB conform You should solder all other board-mounted to the FuzzDog Direct Connection format, so components before you solder the pots. Once can be paired with the appropriate they’re in place you’ll have no access to much of daughterboard for quick and easy offboard the board.
- Page 6 Test the board! Check the relevant daughterboard document for more info before you undertake this stage. UNDER NO CIRCUMSTANCES will troubleshooting help be offered if you have skipped this stage. No exceptions. Once you’ve finished the circuit it makes sense to test is before starting on the switch and LED wiring.
- Page 7 Wire it up (if using a daughterboard please refer to the relevant document) BOARD BOARD INPUT BOARD BOARD BOARD BOARD BOARD BOARD BATTERY Wiring shown above will disconnect the battery when you remove the jack plug from the input, and also when a DC plug is inserted. The Board GND connections don’t all have to directly attach to the board.
-
Page 8: Drilling Template
17 5mm This template is a rough guide only. You should ensure correct marking of your enclosure before drilling. You use this template at your own risk. Pedal Parts Ltd can accept no responsibility for incorrect drilling of enclosures. FuzzDog.co.uk...
Need help?
Do you have a question about the Angry Chuck V3 and is the answer not in the manual?
Questions and answers