Table of Contents
Advertisement
24.
Slide the assembled extrusion through the top of the desired up-post (depending
if you want a RHD or LHD setup, a LHD setup is shown). Slide it down to about
the middle, don't tighten yet.
25.
Prepare the shifter arm lower bracket with 1X M8 X 20 flat head screw, 2 M8
X 20 socket head screws and 3X M8 T-Nuts.
14
Advertisement
Table of Contents
Need help?
Do you have a question about the ASR6 and is the answer not in the manual?