4. Start with the splice clip at one edge of the belt. Using a screwdriver or needle nose pliers unhook one
side of the clip from the belt. Rotate the clip through the belt to unhook its other end and remove it from
the belt.
5. Remove the remaining clips in the same manner to separate the mesh belt.
6. Installation is the reverse of removal. It may be helpful to temporarily bind the ends of the mesh belt
together with tie-wraps while installing the splice clips.
October 10, 2008
VITRONICS-SOLTEC REFLOW SOLDERING SYSTEMS
12
XPM2 / XPM3 Technical Reference Manual
Conveyor Systems
Need help?
Do you have a question about the XPM2 and is the answer not in the manual?