Table of Contents
Advertisement
NOTE
Follow the manufacturer's instructions for powering the controller.
2. Plug your IPC's power cable into a power outlet and turn it on.
3. If there are issues, power off each device, disconnect from power supplies, and check your
wiring.
Configuring Polyscope
Move the UR robot to a safe position close to the base of the robot. This reduces the chance
of the robot faulting during the initialization process.
.................................... © COPYRIGHT READY Robotics ALL RIGHTS RESERVED .................................... 17
Advertisement
Table of Contents
Need help?
Do you have a question about the CB Series and is the answer not in the manual?