Advertisement
Table of Contents
Advertisement
Table of Contents
Related Manuals for Knightsbridge EMPOWER4ST
Summary of Contents for Knightsbridge EMPOWER4ST
- Page 1 INSTALLATION & MAINTENANCE MANUAL EMPOWER4ST/ EMPOWER4WST...
-
Page 2: General Instructions
These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following products: EMPOWER4ST / EMPOWER4WST SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. - Page 3 • This product is Class II double insulated • This product is IP20 rated • Cut a suitable hole in the mounting surface as per the cut-out details (see Fig. 1) ensuring not to infringe with any joists, gas / water pipes or electrical cables INSTALLATION •...
-
Page 4: Self Test Function
• Remove the bezel and lens by inserting a small flat screwdriver into the edge of the bezel and lift out • Fit the required lens and bezel, ensuring the two clips on the rear of the bezel are aligned with the slots on the fitting ... -
Page 5: Warranty
WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. GENERAL The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire should be replaced. - Page 6 TESTING FOR EMERGENCY LUMINAIRES Recommended routine test procedure in accordance with BS5266 • Daily check – check LED charge indicator is illuminated • Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation of key switch or switching off circuit breaker.
- Page 7 230V IP20 25°C 50Hz SUPPLIED BY: (UK) MANUFACTURER (EU) AUTHORISED REPRESENTATIVE ML ACCESSORIES LTD, SLV LIGHTING GROUP, UNIT E CHILTERN PARK, DAIMLERSTRASSE 21-23, BOSCOMBE ROAD, DUNSTABLE 52531 ÜBACH-PALENBERG, GERMANY LU5 4LT, EMAIL: EPREL@GROUP.SLV.COM WWW.MLACCESSORIES.CO.UK AKDEC22_V1 MADE IN CHINA...
- Page 8 230V 50Hz, IP20, Class 2, Non-Dim, Non-IC, house, Ta 0~45...
Need help?
Do you have a question about the EMPOWER4ST and is the answer not in the manual?
Questions and answers