Advertisement

Quick Links

INSTALLATION & MAINTENANCE MANUAL
EMXST
IP
230 V
20
50Hz
54
LTD
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EMXST and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Knightsbridge EMXST

  • Page 1 INSTALLATION & MAINTENANCE MANUAL EMXST 230 V 50Hz...
  • Page 2 These instructions should be used to aid installation of the following product: EMXST INSTRUCTIONS EMXST SAFETY These instructions should be read carefully and retained after installation by the end user for future reference and maintenance.
  • Page 3 n of the fixing holes and drill the holes ensuring not to infringe with any gas/wate • Mark the location of the fixing holes and drill the holes ensuring not to infringe with any gas/water pipes or electrical cables cable through the cable entry hole on the top plate (see Fig. 2) •...
  • Page 4 See below for operation of the self-test function We recommend, on commissioning the installation, a minimum charge period of 24 hours before carrying out an emergency duration test If the batteries have been left in a discharged state for an extended period, we recommend that one or more charge and discharge cycles are completed which should help to restore the battery capacity SELF-TEST FUNCTION This product is programmed to carry out its own self-test function according to the following...
  • Page 5 WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed GENERAL The LED lamps fitted in this product are non-replaceable. The unit should be recycled in the correct manner when it reaches the end of its life.
  • Page 6 TEST RECORD Recommended routine test procedure in accordance with BS5266: • Daily check – check status of bi-colour LED indicator • Monthly functional test - simulate a mains supply failure for approx. 30 seconds by operation of key switch, switching off circuit breaker or using test button. Ensure normal supply is restored after test and check status of bi-colour LED indicator •...
  • Page 7 ML Accessories Limited LU5 4LT www.mlaccessories.co.uk DCMAR19V1...

Table of Contents