Measuring The Front Side Of Black Sheet Rubber - Omron ZS-L User Manual

Section 5

Measuring the Front Side of Black Sheet Rubber

Measuring the Front Side of Black Sheet Rubber
This is an example of how to set when measuring the height from the front side of black
sheet rubber that reflects little light.
1.
Install the Sensor Head.
Basically, install the Sensor Head for diffusion reflection
measurement. Note, however, that the Sensor Head may
be installed for regular reflection measurement if the
amount of received light is little, for example, due to the
rubber sheet having a glossy surface. Adjust the angle of
the Sensor Head while verifying the amount of received
light on the controller's sub-display so that the amount of
received light reaches close to "1000".
FUN Mode-[SENSING]-[MODE]
2.
Select the sensing mode.
Select the sensing mode taking the content of mea-
surement to give priority to into consideration.
[HI-RESO] and [HI-SENS] are best suited for the mea-
surement of black rubber.
ZS-L
5-2
User's Manual
Installing the Sensor Head p.2-12
Setting the Measurement Mode p.3-12
2 HI-RESO
1 STAND
3 HI-SPEED