Programming Features; Hardware; Software (Constant) - Omron VARISPEED V7 User Manual

6 Programming Features

Factory settings of the constants are shaded in the tables.After wiring is
complete, be sure to make the following settings before operation.

Hardware

Make the following settings before the Inverter is turned ON.
Sequence input signal (S1 to S7) polarity selection
Voltage reference / current reference input selection of con-
trol circuit terminal FR

Software (Constant)

Environment
setting
Basic
characteristics
and frequency ref-
erence setting
Motor protection
Countermeasure
for noise and leak-
age current
Using an optional
braking resistor
52
Item
Item
Constant Selection / Initialization (n001)
Control Mode Selection (n002)
Run Command Selection (n003)
Frequency Reference Selection (n004)
Stopping Method Selection (n005)
V/f pattern setting (n011 to n017)
Acceleration Time 1 (n019),
Deceleration Time 1 (n020)
Frequency Reference 1 to 8
(n024 to n031)
Motor Rated Current (n036)
Electric Thermal Motor Protection
Selection (n037)
Carrier Frequency Reference (n080)
Stall Prevention during Deceleration
(n092)
Ref.
page
226
126
Ref.
page
53
59
63
64
106
55
77
74
136
136
94
134