Dreadbox Murmux Adept Edition Operation Manual page 20

Mind that the LFO amount is applied to the parameter of the knob itself and when set at
maximum, it will 'steal' the whole range for better handling.
*LFO B cannot target Master Level knob as well its own parameters (RATE and AMOUNT knobs).
Clear all Target parameters:
●
While holding the TARGET button, press the Encoder in.
●
"CLEAR" message will appear on the screen.
●
Press the Encoder again and all modulation amounts that have been set for the LFO B,
will get cleared.
In order to enable the CLEAR command, the TARGET button needs to be pressed
down. Once CLEAR is shown on the screen, there is no need to keep holding the TARGET
button down.
MASTER
LEVEL: Controls the MASTER Level of the output signal.
SPREAD: Controls the amount of the Stereo Spread by spreading the voices on the Stereo
Spectrum. The voices are split to odd and even on the Stereo Spectrum. So, voices 1,3,5,7 are
set to the left channel and voices 2,4,6,8 are set to the right channel. When SPREAD is set
at zero all voices are mixed to both left and right channels.
SPREAD will also apply a stereo width on the BBD effect, by inverting its LFOs as well as
on the DELAY, by setting a small amount of offset between the delay times.
20