Dreadbox Murmux Adept Edition Operation Manual page 19

When keyboard tracking is applied, the speed set by the RATE knob will always be at
the middle C note. When playing higher notes, it will increase the LFO speed, while
playing lower notes, it will decrease the LFO speed.
WAVE: The WAVE button will cycle through the following LFO Waves: Sine, Triangle, Saw,
Ramp, Square, Random. The WAVE LED will also flash accordingly, to represent the LFO
Waveforms and Rate.
LFO B
RATE: Sets the speed of the LFO. When rotating the knob to the right, it will increase the LFO
speed. Rate values depend on the LFO sync settings of the Menu page. For example, when
LFO BPM Sync is set on the Menu page, the RATE values are divisions of the BPM value.
AMOUNT: Sets the level of the LFO B. The knob is bipolar so we can have both positive
and negative modulation. In the center position, zero modulation occurs. By setting the
AMOUNT to negative level, it will invert the phase of the LFO.
WAVE: The WAVE button will cycle through the following LFO Waves: Sine, Triangle, Saw,
Ramp, Square, Random. The WAVE LED will also flash accordingly, to represent the LFO
Waveforms and Rate.
TARGET: Through the TARGET button you can route LFO B to any* parameter:
●
Press and hold the TARGET button.
●
"L.F.O." message will appear on the screen.
●
While holding the TARGET button, assign LFO B to any parameter by moving any knob
or slider on the panel.
●
The modulation amount is set by the position of the knob or the slider assigned with values
ranging from -99 to 99. On the 0 (zero) position no modulation is applied.
19