Adjusting The Azimuth; Anti-Skating Force Adjustment - Pro-Ject Audio Systems 6 PerspeX Balanced Instructions For Use Manual

Adjusting the azimuth

With the aid of a good magnifying glass adjust the needle until it is vertical in the groove (i.e. perpendicular
to the record's surface). Ideally this should correspond to the top surface of the cartridge body being parallel
to the record surface.
When the needle is vertical, retighten the screw carefully.
Under no circumstances should the arm tube be adjusted with the needle still in the record groove!
!
Irreparable damage may be caused to the cantilever suspension! The arm must be lifted to make
each adjustment and lowered afterwards to check it.

Anti-skating force adjustment

The anti-skating force must be adjusted corresponding to the downforce as follows:
Downforce
10 - 14mN
15 - 19mN
20mN and bigger
Hang the loop of the thread of the anti-skating weight into the groove of the anti-skating stub (15)
corresponding to the downforce applied to your cartridge and hang the thread in the groove of the wire
support (17).
6
© Pro-Ject Audio Systems · 6 PerspeX Balanced · Revision 27.05.2024
Groove in the stub (15)
1 st from bearing rings
2 nd " " "
3 rd " " "