ITW SIMCO ION 1034 Smart SLC IQ Easy 4 User Manual page 72

This parameter determines the default
settings for output voltage and frequen­
cy.
You can choose from 3 presets:
Device type
version
This parameter can be changed from
the Admin user level.
This parameter has 2 modes:
Operation mode
This parameter can be changed from
the Expert user level.
This parameter determines the ratio
between positive and negative ions the
anti-static bar produces.
The default value is 0, producing an
equal number of positive (+) and nega­
tive (-) ions. This parameter ranges
Balance offset
from -100 (100% negative ions) to 100
(100% positive ions).
This parameter can be changed from
the Expert user level (and the Opera­
tion mode parameter then must be set
to Manual).
This parameter determines the default
positive output voltage (when the Bal­
ance offset parameter is set to 0).
Output voltage
The default output voltage positive val­
positive set­ ue is determined by the Device type
version parameter.
point
This value can be adjusted from the
Admin user level for specific applica­
tions.
This parameter determines the default
negative output voltage (when the Bal­
Output voltage
ance offset parameter is set to 0).
negative set­ The default output voltage negative
value is determined by the Device type
point
version parameter.
This value can be adjusted from the
Speed: web speed >500 m/min,
•
web distance 50-500 mm
Hybrid: web speed 0-500 m/min,
•
web distance 100-500 mm
Distance: web distance 100-1000
•
mm
Fixed (default): the anti-static bar
•
uses the default settings.
Manual: parameters related to the
•
output voltage and frequency can
be changed, it is also possible to
use the anti-static bar in CLFB
mode.
72