Evse Power And Status Led Indications; Troubleshooting - Bosch Power Xpress EV800 Series Installation Instructions Manual

9.0 Power and Status LED
Indications
Power LED Status LED
(Off ) (Off )
Green
Amber solid
solid
Green
Green solid
solid
Green Green
solid flashing
1–2 red
Green
flashes every
solid
2 seconds
Solid red,
Green then green
solid flash every 2
seconds
Green
Red flashing
solid
Green
Red solid
solid
Green
(Off )
solid
*See "Troubleshooting" for suggested solutions.
- No illumination
- Solid illumination
- Flashing illumination
Bosch Automotive Service Solutions Inc.
Power Xpress™ Dual Bollard Charge Station Installation Guide | 13 | en

10.0 Troubleshooting

If there is a charging issue proceed with the following steps. If the issue
persists after three attempts call Bosch at 1-877-805-EVSE (3873) for
assistance.
Condition
Problem
Indicated
No service supply
by LED
power
Status
Charge Station
Pilot charg-
powered; vehicle
ing error
coupler not
connected
Waiting to charge
Vehicle charging
Pilot charging error*
Ground
fault
detected
Ground fault
detected*
Ground monitor
interrupted*
Operation fault*
Operation fault*
Ground
monitor
interrupted
Operation
fault
Solution
1. Verify supply-side power. The green
POWER LED should be on. If green
POWER LED is off,
center/panel and reset breaker.
2. Press the master clear RESET button
on the front panel of the Charge
Station to attempt a charge-restart.
3. If the red STATUS
on, disconnect the Charge Station
coupler from the vehicle charge port,
wait 10 seconds, and reconnect the
coupler.
1. Disconnect main service power at
service panel.
2. Disconnect the Charge
coupler from the vehicle.
3. Inspect the Charge
connector and the
port verifying both are clean and
undamaged. If vehicle charge port
needs cleaning, follow manufacturer
instructions for cleaning.
Charge Station connector with a dry
or damp cloth if necessary.
4. Restore main service power.
5. Reconnect the coupler to the vehicle
port.
1. Disconnect main service power at
service panel.
2. Disconnect the Charge
coupler from the vehicle.
3. Inspect the Charge
connector and the
port verifying both are clean and
undamaged. If vehicle charge port
needs cleaning, follow manufacturer
instructions for cleaning.
Charge Station connector with a dry
or damp cloth if necessary.
4. Restore main service power.
5. Reconnect the coupler to the vehicle
port.
1. Verify supply-side power. The green
POWER LED should be on. If green
POWER LED is off,
center/panel and reset breaker.
2. Press the master clear RESET button
on the front panel of the Charge
Station to attempt a charge-restart.
3. If the red STATUS
on, disconnect the Charge Station
coupler from the vehicle charge port,
wait 10 seconds, and reconnect the
coupler.
576414 | REV. A | 28.10.2016
locate load
LED remains
Station
Station
vehicle charge
Clean
Station
Station
vehicle charge
Clean
locate load
LED remains