Omron E5AR-T User Manual page 255

Section 8 Parameters
CH
Segment Editing
Segment Set Point
Segment Rate of Rise
Segment Time
Function
Setting
Setting
Reference
Reference
CH
Wait
Function
Setting
Reference
Reference
8-18
seg.n
sp
pr
time
These parameters are used to make segment settings.
• The Segment Editing parameter is used to set the segment number
of the segment to be set.
• The Segment Set Point parameter is used to set the set point for
each segment. During rate of rise programming, the Segment Set
Point parameter is used to set the destination set point.
• The Segment Rate of Rise parameter is used to set the amount of
change per rate of rise programming time unit.
• The Segment Time parameter is used to set the segment time.
For rate of rise programming, the Segment Time parameter is used to
set the soak segment time.
Parameter
end
Segment Editing
of Segments Used parameter
Segment Set Point SP lower limit to SP upper limit
Segment Rate of 0 to 99,999
Rise
Segment Time 0.00 to 99.59 or 0.00.0 to
99.59.9
● Related Information
4.8 Program Settings (P. 4-23)
wait
• This parameter is used to set whether or not to use the wait function.
Setting range
off
: Disabled
on
: Enabled
● Related Information
Wait in 5.7 Program Operation Functions (P. 5-32)
CH2 for independent operation
Segment Rate of Rise during
Rate of Rise programming only
Setting range
EU
, 1 to setting of Number
EU
EU
Program
time unit
CH2 for independent operation
Unit Default value
off
: Disabled
CH1 or
Default
Unit
value
end
0
0
0.00
CH1 or