Creating Function Block Data - Omron CX-PROCESS TOOL - INTRODUCTION GUIDE Introduction Manual

Creating Function Block Data

Thermocouple
Input Unit
Function Block Data
CJ1W-PTS51
Field Terminal Block for
Analog Input (Isolated
Type K
Ai 4-point Terminal
thermocouple
(PTS51)) (Block Model
566)
Inputs the analog signal
from the CJ1W-PTS51.
To simplify descriptions, operations for startup settings at the PLC
(such as creating I/O tables (see note) and setting DM Area words
allocated to Analog I/O Units) is not included in the following
description of operations for the CX-Process Tool. Be sure to
separately make the settings using the CX-Programmer.
Note: With CJ-series Loop-control CPU Units, I/O tables can be automatically generated
Control Block for PID
Control (Basic PID)
(Block Model 011)
Performs PID
calculations.
(in CJ-series CJ1G-CPU45P Loop-control CPU Unit)
based on the mounted Units when the power supply is turned ON without
performing the operation to create I/O tables. (With CS-series CPU Units, an
operation must be performed to create the I/O tables.)
Loop Controller
Field Terminal Block for
Analog Output (Ao 4-
point Terminal (DA041)
(Block Model 587)
Outputs the analog
signal from the CJ1W-
DA041.
Analog Output Unit
CJ1W-DA041
4 to 20 mA