Uploading And Saving Function Block Data - Omron CX-PROCESS TOOL - INTRODUCTION GUIDE Introduction Manual

11
11

Uploading and Saving Function Block Data

Uploading and Saving Function Block Data
Upload the data from the actual
Loop Controller and save the
data in a file.
Upload the parameters (e.g., PID con-
stants) tuned in the actual Loop Con-
troller to the computer. Right-click
in the tree in the
window on the left and select Transfer
from LC - Previous.
Click the OK Button.
Click the Start Button.
Transferring the setting parameters
from the Loop Controller to the comput-
er will begin. The window will close
when the transfer has been completed.
Click the Save Button
to save the function block data.
Tuned function
block data
Loop Controller
11-1. Upload the data from the actual Loop Controller.
11-1-1.
Click the OK Button.
on the toolbar
11-2. Save the function block data.
Right-click and select Transfer from LC - Previous.
11-1-2. Start the transfer.
Saving data
11
1-19