Omron CPM1A Operation Manual page 51

Specifications
Transistor Outputs (Sinking)
Item
CPM1A-
10CDT-j(-V1)
+10%
Max.
24 VDC
switching
capacity p y
0.9 A/Unit
Leakage 0.1 mA max.
current
Residual 1.5 V max.
voltage
ON delay 0.1 ms max.
OFF delay OUT01000/01001: 0.2 ms max. (load current: 100 to 300 mA)
Other than OUT01000/01001: 1 ms max. (load current: 5 to
300 mA)
Fuse V1 CPU Units: No fuse
Expansion I/O Units and Pre-V1 CPU Units 1.25 A/common (cannot be replaced by the user)
Circuit
configuration
28
CPM1A-
CPM1A-
20CDT-j(-V1)
30CDT
/ , 0.3 A/point (see note)
–15%
0.9 A/common 0.9 A/common
1.8 A/Unit 2.7 A/Unit
0.5 ms max. (load current: 5 to 100 mA)
Output LED
Internal
Circuits
Note When using the OUT01000 or OUT01001 as a pulse output, connect dummy
resistors as required to set the load current to 0.1 to 0.2 A. If the load current is
below 0.1 A, the ON-to-OFF response time will become longer and high-speed
pulse will not be output. On the other hand, if the load current is above 0.2 A, the
transistor may generate heat and components may be damaged.
Specification
CPM1A-
j(-V1) j(-V1)
- -
40CDT
0.9 A/common
3.6 A/Unit
OUT
OUT
COM (–)
Section 2-1
CPM1A-20EDT CPM1A-8ET
4.5 to 30 VDC
0.2 A (See note 2.)
0.3 A (See note 3.)
0.9 A/common
1.8 A/Unit
1 ms max.
+10%
(24 VDC / , 5 to 300 mA)
–5%
24 VDC