Omron CPM1A Operation Manual page 52

Specifications
Transistor Outputs (Sourcing)
Item
CPM1A-
10CDT1-j(-V1)
+10%
Max. 24 VDC
switching
capacity p y
0.9 A/Unit
Leakage 0.1 mA max.
current
Residual 1.5 V max.
voltage
ON delay 0.1 ms max.
OFF delay OUT01000/01001: 0.2 ms max. (load current: 100 to 300 mA)
Other than OUT01000/01001: 1 ms max. (load current: 5 to 300 mA)
Fuse V1 CPU Units: No fuse
Expansion I/O Units and Pre-V1 CPU Units 1.25 A/common (cannot be replaced by the user)
Circuit
configuration
! Caution
CPM1A- CPM1A-
20CDT1-j(-V1) 30CDT1-j(-V1)
/ , 0.3 A/point (See note.)
–15%
0.9 A/common 0.9 A/common
1.8 A/Unit 2.7 A/Unit
0.5 ms max. (load current: 5 to 100 mA)
Internal
Circuits
Note When using the OUT01000 or OUT01001 as a pulse output, connect dummy
resistors as required to set the load current to 0.1 to 0.2 A. If the load current is
below 0.1 A, the ON-to-OFF response time will become longer and high-speed
pulse will not be output. On the other hand, if the load current is above 0.2 A, the
transistor may generate heat and components may be damaged.
Do not apply voltage in excess of the maximum switching capacity to an output
terminal. It may result in damage to the product or fire.
Specification
CPM1A-
40CDT1-j(-V1)
0.9 A/common
3.6 A/Unit
Output LED
COM (+)
OUT
OUT
Section 2-1
CPM1A- CPM1A-8ET1
20EDT1
4.5 to 30 VDC
0.2 A (See note 2.)
0.3 A (See note 3.)
0.9 A/common
1.8 A/Unit
1 ms max.
+10%
(24 VDC / , 5 to 300 mA)
–5%
24 VDC
29