Glossary - Omron CPM1A Operation Manual

data link
data link area
data movement instruction
data sharing
data trace
data transfer
debug
decimal
decrement
default
definer
destination
differentiated instruction
differentiation instruction
digit
digit designator
DIN track
DIP switch
direct output
distributed control
162

Glossary

An automatic data transmission operation that allows PCs or Units within PC to
pass data back and forth via common data areas.
A common data area established through a data link.
An instruction used to move data from one location in memory to another. The
data in the original memory location is left unchanged.
The process in which common data areas or common data words are created
between two or more PCs.
A process in which changes in the contents of specific memory locations are
recorded during program execution.
Moving data from one memory location to another, either within the same device
or between different devices connected via a communications line or network.
A process by which a draft program is corrected until it operates as intended.
Debugging includes both the removal of syntax errors, as well as the fine-tuning
of timing and coordination of control operations.
A number system where numbers are expressed to the base 10. In a PC all data
is ultimately stored in binary form, four binary bits are often used to represent
one decimal digit, via a system called binary-coded decimal.
Decreasing a numeric value, usually by 1.
A value automatically set by the PC when the user does not specifically set
another value. Many devices will assume such default conditions upon the
application of power.
A number used as an operand for an instruction but that serves to define the
instruction itself, rather that the data on which the instruction is to operate. Defin-
ers include jump numbers, subroutine numbers, etc.
The location where an instruction places the data on which it is operating, as
opposed to the location from which data is taken for use in the instruction. The
location from which data is taken is called the source.
An instruction that is executed only once each time its execution condition goes
from OFF to ON. Non-differentiated instructions are executed for each scan as
long as the execution condition stays ON.
An instruction used to ensure that the operand bit is never turned ON for more
than one scan after the execution condition goes either from OFF to ON for a
Differentiate Up instruction or from ON to OFF for a Differentiate Down instruc-
tion.
A unit of storage in memory that consists of four bits.
An operand that is used to designate the digit or digits of a word to be used by an
instruction.
A rail designed to fit into grooves on various devices to allow the devices to be
quickly and easily mounted to it.
Dual in-line package switch, an array of pins in a signal package that is mounted
to a circuit board and is used to set operating parameters.
A method in which program execution results are output immediately to elimi-
nate the affects of the cycle time.
A automation concept in which control of each portion of an automated system is
located near the devices actually being controlled, i.e., control is decentralized