Online Operations - Omron CPM1A Operation Manual

Support Software Capabilities

4-1-4 Online Operations

Group Name
Monitoring Monitor Data
Transfer Program
Change Display
Online Edit
Read Cycle Time
Clear Area
Search
I/O Comments
Block Comments
Memory Usage
DM
Transfer
PC —> Computer
Transfer
Computer—>PC
Transfer
Verify
Monitor
Go To Page
I/O Table Transfer I/O Table
Create I/O Table
Verify I/O Table
Utility File Memory/
Memory Card
Time Chart Monitor
Instruction Trace
Data Trace
Debug
Display/Set Clock
Transfer Instr
PC Setup
Network Support
Tables
82
The following operations are possible when connected online to the PC.
Uses the lower one third of the screen as a monitor area where bits, words, DM
contents, and TIM/CNT SV/PV are monitored, forced-set/reset, and changed.
Transfers and compares the user program between the computer and PC.
C-series PCs
Ladder W/Comments
Ladder
CVM1 PCs
Ladder
Ladder (2 rows of comments)
Ladder (4 rows of comments)
Simultaneously edits the PC program and the program in the system work area.
Reads and displays the scan time of the PC.
Clears the PC data areas such as HR, CNT, AR, and DM (to zero).
Searches for instructions (including specified operands).
Searches for I/O comments.
Searches for block comments.
Displays used program memory area, the number of comments used, and the
available capacity of the internal memory.
Retrieves PC DM data to the system work area. (C-series PCs only)
Writes system work area DM data to the PC. (C-series PCs only)
Compares DM data between the system work area and PC. (C-series PCs only)
Used to monitor DM area contents in the PC. (C-series PCs only)
Reads a specified page from the DM list of the DM area in the system work area
or PC. (C-series PCs only)
Transfers and compares the I/O table data between the computer and PC.
Registers into the PC the I/O Units mounted on the PC and then assigns the
words to the Units.
Compares the I/O table registered in the PC against the I/O Units actually
mounted on the PC.
Displays a file memory list; transfers the file memory contents between the PC
and computer or the PC and File Memory Unit; clears the file memory; saves or
retrieves the file memory contents to or from a floppy disk; and edits file memory
contents
Used to execute time chart monitoring and to display, save, or retrieve results.
(C-series PCs only)
Used to execute instruction traces and used to display, save, or retrieve results.
(C-series PCs only)
Used to execute data traces and used to display, save, or retrieve results.
Used to display the execution status of the specified program section.
(C-series PCs only)
Used to read and set the internal clock in the PC. (CQM1, C200HS, or CVM1
only)
Used to transfer expansion instruction set from the PC to the SSS.
(C-series PCs only)
Changes the PC Setup in the PC and in the system work area and used to
transfer the PC Setup between the PC the disk (save/retrieve).
C-series PCs: Used to input data link tables for SYSMAC NET.
CVM1 PCs: Used to transfer data link tables and routing tables between Link
Units, the PC, and the SSS and to compare these tables. Also used
to start and start data links.
Description
Section 4-1