Keypad Operation; Digital Operator Display (Optional - Omron CIMR-L7Z Quick Manual

Keypad Operation

Digital Operator Display (optional)

The key names and functions of the Digital Operator are described below
Digital Operator Keys
Key
Note: Except in diagrams, Keys are referred to the key names listed in the above table.
EN-11
Name
Switches between operation via the Digital Operator (LOCAL) and the settings in
LOCAL/REMOTE Key
b1-01 and b1-02 (REMOTE).
This key can be enabled or disabled by setting parameter o2-01.
MENU Key Selects menu items (modes).
ESC Key Returns to the status before the DATA/ENTER key was pressed.
Starts jog operation when the inverter is operated by the Digital Operator and d1-18
JOG Key
is set to 0.
Selects the rotation direction of the motor when the Inverter is operated by the Dig-
FWD/REV Key
ital Operator.
Sets the active digit when programming parameters.
Shift/RESET Key
Also acts as the Reset key when a fault has occurred.
Selects menu items, sets parameter numbers, and increments set values.
Increment Key
Used to move to the next item or data.
Selects menu items, sets parameter numbers, and decrements set values.
Decrement Key
Used to move to the previous item or data.
DATA/ENTER Key Enters menus and parameters, and set validates parameter changes.
RUN Key Starts the Inverter operation when the Inverter is controlled by the Digital Operator.
Stops Inverter operation.
STOP Key
This key can be enabled or disabled using parameter o2-02 when operating from a
source different than the operator.
Drive Status Indicators
FWD: Lights up when a forward run command is input.
REV: Lights up when a reverse run command is input.
SEQ: Lights up when any other run command source
than the digital operator is selected
REF: Lights up when any other frequency reference
source than the digital operator is selected
ALARM:Lights up when an error or alarm has
occurred.
Data Display
Displays monitor data, parameter numbers and param-
eter settings.
Mode Display (displayed at the upper left of data display)
DRIVE: Lights up in Drive Mode.
QUICK: Lights up in Quick Programming Mode.
ADV: Lights up in Advanced Programming Mode.
VERIFY: Lights up in Verify Mode.
A. TUNE: Lights up in Autotuning Mode.
Keys
Execute operations such as setting parameters, moni-
toring, jogging, and autotuning.
Function