Instructions For Mac Os X; Install The Wiced Sdk And Ide; Connect The Wiced Evaluation Board; Figure 3: Wiced Sdk Os X Setup - Broadcom WICED Quick Start Manual

Quick Start Guide
WICED Setting Up the WICED SDK

Instructions for Mac OS X

Install the WICED SDK and IDE

The WICED SDK is provided as an OS X package installer. Double-click the Wiced-SDK-2.3.x.pkg file to begin
the installation. A setup window similar to Figure 3 displays.

Figure 3: WICED SDK OS X Setup

Click Continue once to read the welcome note, then click Continue again and select installation permissions.
After installation permissions are selected, click Continue and then click Install. Enter your account password
if asked, and follow the prompts to complete the installation.

Connect the WICED Evaluation Board

The USB interface connects the WICED evaluation board to the Mac. The USB interface provides +5V power
as well as individual programming/debug and UART interfaces to the microcontroller on the WICED module. A
separate +5V power supply is not required.
The WICED evaluation board has two logical USB devices: a USB-JTAG device and a USB-UART device. A
driver for the WICED evaluation board is included with the OS X operating system.
Plug the WICED evaluation board into the Mac with a USB cable, the driver automatically loads. Verify the
WICED evaluation board 3V3 LED is ON indicating the board is powered. If the LED is not on, replace the USB
cable and try again.
Broadcom
®
January 15, 2014 • MMPWICED-QSG203-R Page 12