Summary of Contents for SelectBlinds Classic Roman Shades
Page 1
® INSTALLATION GUIDE Simple. Smart. Custom. ROMAN SHADES LIFT SYSTEMS: CONTINUOUS CORD LOOP | MOTORIZATION The difficulty level of this installation is ranked at Level 1. A piece of cake! If you have questions or get stuck, call our Customer Care Team at 888-685-1735, or email info@selectblindscanada.ca HARDWARE AND PARTS INCLUDED TOOLS REQUIRED BRACKET...
INSIDE MOUNT 1. Measure 2”- 4” in from each side of the window frame, and mark once with a pencil for your outer brackets. The front of the bracket will face out from the window, and the back of it will hang down parallel to the window.
Page 3
ATTACHING THE SHADE INSIDE AND OUTSIDE MOUNT NOTE: For outside mount, use your level to check that the brackets are straight before you proceed. 1. With the front of the shade facing you, and holding it at a slight downward-angle, rest the lip of the headrail against the movable tab in each of the brackets.
Page 4
PROGRAMMING AND USING YOUR REMOTE MOTORIZED ROMAN SHADES WARNING: DO NOT attempt to raise or lower your motorized shade with your hands. This may cause permanent damage to the motor, and other components in the headrail, which may not be covered under your warranty.
Page 5
BACK PAIRING THE REMOTE WITH A MOTOR NOTE: The factory pairs each of your shades to the remote. The following steps are only necessary if you want to change how the channels are configured, or if you are adding a new shade to a remote already in use.
Page 6
ADJUSTING UPPER AND LOWER LIMITS NOTE: The upper and lower limits are already set-up at the factory, so the following steps are only necessary if you want to change how these settings are configured. Both limits must be reprogrammed in these instructions.
® INSTALLATION GUIDE Simple. Smart. Custom. ROMAN SHADES LIFT SYSTEMS: STANDARD LIFT | CORDLESS LIFT The difficulty level of this installation is ranked at Level 1. A piece of cake! If you have questions or get stuck, call our Customer Care Team at 888-685-1735, or email info@selectblindscanada.ca HARDWARE AND PARTS INCLUDED TOOLS REQUIRED LEVEL...
Page 8
OUTSIDE MOUNT 1. Center and hold the headrail at least two inches above the window. While keeping the shade level, make a small line with your pencil just above each of the pre-drilled holes in the headrail. Set the shade aside. 2”...
Page 9
ATTACHING THE CORD CLEAT STANDARD CORDED SHADES WARNING: Blinds and shades with cords present a strangulation risk for young children and pets. Cord cleats are included as an important safety feature. Please follow the steps below to properly install them. If you need extra cleats, call our Customer Care team SCREW and we’ll send them to you for free.
CLEANING INSTRUCTIONS NOTE: All fabrics are different and some may be easier to clean than others. We recommend cleaning your shades as often as once a month. Here are some general guidelines on how to do so: 1. For regular maintenance, use a duster or a vaccum with a brush attachment and run it over the front and back of the shade.