Putting The Devices Into Operation; Em 100 Receiver - Sennheiser 100 - 01-09 Instruction Manual

Putting the devices into operation

EM 100 receiver

Setting up the receiver on a flat surface
Place the receiver on a flat, horizontal surface. Please note that the device feet can leave
stains on delicate surfaces.
Fastening the stacking To fasten the stacking elements
elements
Fitting the device feet The device feet are fitted to the base of the receiver (see diagram).
You can set up the receiver on a flat surface or mount it into a 19" rack. For informa-
tion on rack mounting, refer to the instruction manual of the EM 100 receiver avail-
able on the ew G3 product page at www.sennheiser.com.
The stacking elements are designed to help protect the operating elements from
damage or deformation, e.g. if the receiver is dropped. Therefore, fasten the
stacking elements, even if you do not want to stack your receivers.
Unscrew and remove the two recessed head screws (M4x8) on each side of the receiver
(see diagram).
Secure the stacking elements
recessed head screws (see diagram).
If you want to stack receivers (see following section), only fit the device feet to the
base of the lowermost receiver.
Clean the base of the receiver where you want to fix the device feet.
Fix the device feet to the base of the receiver by peeling off the backing paper and fitting
them as shown on the left.
Putting the devices into operation
:
to the sides of the receiver using the previously removed
11