Synchronizing A Transmitter With The Receiver - Sennheiser 100 - 01-09 Instruction Manual

Using the devices
·
³
·
³
20
To switch the radio microphone
operation):
Press the ON/OFF
ON/OFF
Press the multi-function switch ¸.
The transmission frequency is displayed but the radio microphone does not
transmit an RF signal. The transmission icon
MHz
543.200
ew100 G3
P
MUTE
AF
Use this function to save battery power or to prepare a radio microphone for use
during live operation without causing interference to existing transmission links.
To activate the RF signal:
Briefly press the
ON/OFF
"RF Mute Off" appears on the display panel.
Press the multi-function switch ¸.
The transmission icon

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the ew 100 G3 series with the receiver. During
synchronization, the following parameters are transferred to the transmitter:
Setting
"Frequency Preset"
"Name"
"Pilot Tone"
To transfer the parameters:
Switch the transmitter and the receiver on.
Press the button
"Sync" appears on the display panel of the receiver.
Place the infra-red interface of the transmitter (see page 7 and 9) in front of the infra-
red interface of the receiver ·.
The parameters are transferred to the transmitter. When the transfer is completed, " "
appears on the display panel. The receiver then switches back to the current standard
display.
To cancel the transfer:
Press the STANDBY button on the receiver.
on and to deactivate the RF signal on switch-on
¹
button until "RF Mute
button ¹.
ON/OFF
is displayed again.
Transferred parameters
Currently set frequency
Freely selectable name currently set on the receiver
Current pilot tone setting of the receiver ("Inactive"/"Active")
³
on the receiver.
On?" appears on the display panel.
is not displayed.
(offline