Putting The Transmitter Into Operation; Setting Up The Transmitter On A Flat Surface; Mounting The Transmitter Into A 19" Rack; Connecting The Antennas - Sennheiser SR 2000 IEM - 01-09 Instruction Manual

Putting the transmitter into operation

CAUTION!
8
Putting the transmitter into operation

Setting up the transmitter on a flat surface

Do not fit the device feet when mounting the transmitter into a 19" rack.
Clean the base of the transmitter where you want to fix the device feet.
Fit the device feet to the four corners of the transmitter.
Place the transmitter on a flat, horizontal surface. Please note that the device feet can
leave stains on delicate surfaces.

Mounting the transmitter into a 19" rack

Risks when rack mounting the transmitter!
When installing the device in a closed or multi-rack assembly, please consider that, during
operation, the ambient temperature, the mechanical loading and the electrical potentials will
be different from those of devices which are not mounted into a rack.
Make sure that the ambient temperature within the rack does not exceed the permissible
temperature limit specified in the specifications.
If necessary, provide additional ventilation.
Make sure that the mechanical loading of the rack is even.
When connecting to the power supply, observe the information indicated on the type
plate. Avoid circuit overloading. If necessary, provide overcurrent protection.
When rack mounting, please note that intrinsically harmless leakage currents of the
individual mains units may accumulate, thereby exceeding the allowable limit value. As a
remedy, ground the rack via an additional ground connection.
Slide the transmitter into the 19" rack.
Secure the rack mount "ears"
delivery).

Connecting the antennas

You have the following options:
• For professional use, we recommend connecting a remote antenna and, if necessary, using
Sennheiser antenna accessories (see next section and the chapter "Connecting several
transmitters to a remote antenna" on page 9).
• If the transmitter is to be put into operation without a large amount of installation work,
you can:
– connect the supplied rod antenna to the rear of the transmitter (see page 9) or
– use the optional GA 3030 AM antenna front mount kit (see page 9).
to the rack using four screws (not included in the