Using The Devices; Switching The Devices On/Off - Sennheiser 100 - 01-09 Instruction Manual

00 G3
00
MHz
SET
²
º

Using the devices

To establish a transmission link, proceed as follows:
1. Switch the receiver on.
2. Switch a transmitter on.
The transmission link is established and the receiver's RF level display "RF" reacts.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
If necessary, read the chapter "If a problem occurs ..." on page 28.
It is vital to observe the following notes:
Make sure that the desired frequencies are listed in the enclosed frequency
information sheet.
Make sure that the desired frequencies are approved and legal in your country
and, if necessary, apply for an operating license.

Switching the devices on/off

EM 100 receiver
To switch the receiver on:
Briefly press the
The receiver switches on and the
To switch the receiver to standby
If necessary, deactivate the lock mode (see page 21).
Keep the STANDBY
When in the operating menu, pressing the
(ESC function) and return you to the current standard display.
º
²
.
STANDBY button
"Receiver Parameters" standard display appears.
mode:
²
button pressed until "OFF" appears on the display panel.
STANDBY
Using the devices
²
button will cancel your entry
17