Table of Contents
Advertisement
LCD hinges
Follow the instructions to replace the LCD hinges.
For access, remove these FRUs in order:
• "Base cover assembly" on page 58
• "LCD unit" on page 82
• "LCD bezel sheet" on page 84
• "Strip cover" on page 85
• "Hinge cap" on page 86
Step 1.
Remove the LCD hinges as shown below.
Table 11. Screw specification
Step
Screw (quantity)
1
M2.5 × 2.3 mm, flat-head, nylon-coated (6)
Step 2.
Install the LCD hinges in reverse order.
LCD panel, LCD cable and elastic adhesive tapes
Follow the instructions to remove the LCD panel and elastic adhesive tapes.
For access, remove these FRUs in order:
• "Base cover assembly" on page 58
• "LCD unit" on page 82
• "LCD bezel sheet" on page 84
• "Strip cover" on page 85
• "Hinge cap" on page 86
Step 1.
Remove the LCD panel, LCD cable and elastic adhesive tapes as shown below.
a.
Pull out each tape slowly in the direction as shown until the adhesive tapes are all released
from LCD unit, and turn over the LCD panel.
Note: Do not pull the tapes too fast, otherwise, the tapes might snap.
Color
Torque
Black
0.294 Nm
(3.0 kgf-cm)
.
Chapter 8
Removing or replacing a FRU
87
Advertisement
Table of Contents
